Det-tronics Mac - w/Supercard Manual de usuario descargar pdf (Pagina 62)

Com 1/Com 2 These indicators track the fault isolation status

of the module. If the left side has isolated

due to a network fault, the “Com 1” indicator

will turn red. If the right side has isolated, the

“Com 2” indicator will turn red.

Fault This indicator will turn red when a hardware

fault has been detected.

Low Voltage This indicator will turn red when the supply

voltage to the module drops below 17.5 vdc.

Digital Input 1/ These indicators track the status of the two

Digital Input 2 digital inputs and will turn red when the input

is active.

Unable to Configure This indicator will turn red if EagleVision was

unable to successfully download configura-

tion information to the target module.

Output Relay Active This indicator turns red when the onboard

relay is active.

Inhibit Active This indicator will turn red when the point has

been “inhibited” by the using the point dis-

plays inhibit button. When “inhibited” any

gateway relays programmed to monitor the

status of the point will ignore its data. In

addition, the gateway faceplate will not

respond to status changes in the inhibited

point.

Relay Module Point Display

GENERAL INFORMATION

INDICATORS

3.8

95-8434

A1817

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 75 76

Sin comentarios

Det-tronics Mac - w/Supercard Manual de usuario Pagina 62