Det-tronics S3 Graphics Manual de usuario descargar pdf (Pagina 321)

13-96

EQP LOGIC EDITOR

Version 6.0

Item 314 - Serial Port 2 Parity

The parity setting for the second conﬁgurable serial port is set with this variable. The default parity is “None”.

Refer to the data type section of this document for the parity data values.

Item 315 - Serial Port 2 Address

This address ﬁeld is used for Modbus protocol, valid Modbus addresses are in the range from 1 to 247 with a

default value of 1.

Item 316 - Serial Port 3 Protocol

Serial Port Protocols

Value

Description

Port not used

Modbus Slave

Modbus Master

4 S

Item 317 - Serial Port 3 Baud Rate

Serial baud rate for serial port 3 is set with this variable. . The allowed selections are listed below.

Baud Rate Codes

Code

Speed

9600

19.2K

38.4K

6 57.6K

115.2K

230.4K

Item 318 - Serial Port 3 Parity

Serial port 3 parity is set with this variable. The default parity is “None”. Refer to the data type section of this

document for the parity data values.

Item 319 - Serial Port 3 Address

The address ﬁeld is only used for Modbus protocol. Valid Modbus addresses are in the range from 1 to 247. The

default address is 1.

Item 320 - Serial Port 4 Protocol

Serial Port Protocols

Value

Description

Port not used (Debug Output)

Modbus Slave

Modbus Master

DEVICE ITEM NUMBER DESCRIPTIONS

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 327

Sin comentarios

Det-tronics S3 Graphics Manual de usuario Pagina 321