Det-tronics S3 Graphics Manual de usuario descargar pdf (Pagina 38)

5-3

PRINTING

Version 6.0

Selecting ports to document

Port 1 - 10

supports up to ten ports. Each port can be physical serial port or an Ethernet

connection.

NOTE

A single Ethernet card can support multiple ports!

In the example to the right, ports one and three are conﬁgured and therefore

selectable. The ports not conﬁgured are grayed out.

Each selected port will have its documentation printed.

Port documentation includes all aspects of the conﬁguration including the

communication parameters and any conﬁgured points, events, alarms,

setpoints, custom event names, etc. Each conﬁgured point has one page of

printed conﬁguration data.

Once all of the selections for the documentation and ports to print have been

made, select the “OK” button to access the “Print Setup” dialog box for the

Windows-NT/2000/XP/Vista default printer and continue the printing process.

Once the print conﬁguration is set, selecting OK will display the “Print Setup”

dialog box for the Windows-NT/2000/XP/Vista default printer.

In the example below an HP LaserJet 5000 network printer is the

Windows-NT/2000/XP/Vista default.

Depending on the default printer installed the dialog box and choices available will vary.

NOTE

The Okidata event and alarm

printer specied for use with

can be congured as the

Windows-NT/2000/XP/Vista

default printer and used for

documentation. However, due to

the volume of paper and printer

speed, it is not recommended.

PORT SELECTION

DOCUMENTATION SELECTION

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 326 327

Sin comentarios

Det-tronics S3 Graphics Manual de usuario Pagina 38